00:00You know that sinking feeling when drilled bit punches through and blows out the back of your
00:03workpiece? Yeah. That stops today. I dug through 5 depth stopper sets that fix crooked, overshot
00:12drilling holes, and these are the best deals I found. First up, the stainless steel stop collar
00:17set, 3mm to 16mm stainless means the set screws don't strip out after a week of tightening like
00:23the cheap zinc ones do. Hex wrench comes in the box, so nothing extra to buy. At $3.73 with
00:31almost
00:325,000 sold and a 4.9 rating, this is the cheapest way to stop blowing out holes. Next, the
00:38adjustable
00:39positioner collar set at $5.23. Same idea, more sizes, and the collar slide smooth and lock down
00:46hard with the Allen wrench. If you drill a lot of mixed bit sizes in one session, the wrench here
00:52saves you from swapping collars constantly. 4.9 stars, near 5,000 sold. Solid buy. Third one,
01:01basically same set, $4.81. Cheaper buy about $0.40 and rated the same 4.9. Honestly if the first
01:10two
01:11are sold out, this is your move. Same set screw design, same wrench, same job. No reason to
01:18overthink it. Then there's the limiter collar kit at $4.89. This one's rated 4.6, a touch lower,
01:27but it's the one with the guide and gauge setup, so you can dial in exact depth instead of eyeballing
01:31the collar position. Worth it if you're doing repeatable work like shelf pins or dowel holes.
01:38Last, the 9 or 18 piece set for $4.35. Best value per collar on the list.
01:45If you want a stopper already on every bit in your rack and never want to hunt for one mid
01:49-project,
01:50buy this. 4.8 stars, over 4,500 sold. Skipped, on-camera B-roll cues, add when shooting.
