• 17 minutes ago

Category

🎈
Fun
Transcript
00:00Master craftsmen have marking tricks most people can't figure out.
00:031. When tile setters run into an angled corner, there's often a big gap left at the top.
00:08An experienced craftsman holds a framing square against the wall and transfers the exact angle onto the tile.
00:13After cutting, it fits perfectly.
00:152. When they run into a curved wall, they simply grab a spare cutting disc and use it to trace
00:20the curve of the wall onto the tile.
00:22After cutting, the fit is perfect with no gaps.
00:253. Installing baseboards around a corner like this can leave beginners completely stumped.
00:30Lay the board flat against the inside corner.
00:32Mark a 45-degree line along the outside corner.
00:34Cut it and put the board back in place.
00:36Then mark another 45-degree line at the same spot.
00:39Cut it and fit the trimmed piece back into place.
00:42Push this piece upward and the joint fits perfectly.
00:454. What about marking an outside corner?
00:47Flip the baseboard over, then lay a right-angle triangle ruler across it and draw a line.
00:52Next, draw these two vertical lines, cut along both marked sections, flip it back over, and the pieces fit together
00:57perfectly.
00:585. Leaving an outside corner, trim unfinished looks terrible.
01:02Hold a framing square against it and push the trim outward.
01:05Mark the position and draw a vertical line, then draw a 45-degree line.
01:09Draw another line on the inside edge as well.
01:11Cut along the marked lines, fit this piece back in place, and you've got a perfectly finished corner.
01:166. This trick is even more clever.
01:19First, secure a U-shaped wooden positioning jig, then tap the wooden board into place.
01:236. Mark the section that sticks out, trim it off, and turn the board around.
01:27Tap it back into place, and the fit is perfect.
01:306. The fit is perfect.